Owner's Manual

- 2 -
Assembling the Main Frame
1. Place the Deluxe Activity Rocker on the floor.
Kneel down behind the seat. (A)
2. You must reset and balance the armrest reclining
position slot guides before proceeding.
To balance the slots guides:
Squeeze the reclining lever (B) located behind the
seat and push the seat forward to full upright
position. Then release the reclining lever to lock the
seat into position. Check to make sure the armrest
slot guides are in the same forward locked position.
(C)
3. To connect the leg (D) to the frame, grasp the top
of the leg with one hand and the frame (next to the
armrest) with the other hand. (E)
4. Insert the leg into the opening of the frame tube
until you hear a click and the lock pin can be seen
through the hole in the armrest
5. Be sure that the seat cushion’s metal hooks
(located above and below the armrest) go over the
frame and snap under the seat cushion.
6. To make sure that the Deluxe Activity Rocker is ready
for use, place one hand behind the top of the seat
cushion and push up until the folding lever (F) slides
completely forward into place.
Attaching the Canopy
Attaching the Canopy
To install the canopy place the notch in the clamp of the canopy holder into the
hole on the reclining tube. (Located above the armrest).
Note:
Clamp must be positioned behind the canopy holder in order to insert into the frame.
Canopy
Holder
Clamp
Reclining Tube
Armrest reclining
position slot guides.
Kneel behind
the seat to
reset and
balance the
armrest
reclinging
guides.
Recline
release
lever
located
behind the
seat.
(A)
(B)
(C)
Armrest
Front leg
Armrest reclining
slot guide.
Note: Both armrest slot
guides must be locked
in the forward position
before connecting the
leg to the frame tube.
(D)
(E)
Frame Tube
(F)
Lock Pin
WARNING
Never lift Deluxe Activity Rocker using the canopy.