User's Manual

MIRCU User Manual
© Comba Telecom Ltd. All Rights Reserved Page 7 of 24
2
nd
Primary
1
st
Primary
Scan
Calibrat
ion
Set Tilt
L2
Restora
tion
L7
Restora
tion
Update
Config
file
Update
Firmwar
e
Informa
tion
Set
Device
Data
Self-test
Scan √ √ √ √ √ √ √ √ √ √
Calibration √ X X √ √ X X √ √ √
Set Tilt √ X X √ √ X X √ √ √
L2 Restoration √ √ √ √ √ √ √ √ √ √
L7 Restoration √ √ √ √ √ √ √ √ √ √
Update
Config file
X X X X X X X X X X
Update
Firmware
X X X X X X X X X X
Information √ √ √ √ √ √ √ √ √ √
Set Device
Data
√ √ √ √ √ √ √ √ √ √
Self-test √ √ √ √ √ √ √ √ √ √
X ： Note 1) MIRCU cannot operate the commands from 2 respective primaries simultaneously.
It conflicts each other and doesn’t comply with AISG standard.
Note 2) 1 primary can operate the command successfully, but the command sent by
another primary failed to achieve.
√ ： Note 1) MIRCU-S24 can operate the commands from 2 respective primaries
simultaneously, and comply with AISG standard.
Note 2) Although ‘Update Config File’ and ‘Update Firmware’ can run on 2
nd
primary
while 1
st
primary is performing an action, the link on 1
st
primary will break then and all
actions will stop and fail to operate.
a) Scan
MIRCU-S24 supports 2 primaries to scan MIRCU simultaneously. When 1
st
primary is
scanning, the 2
nd
primary is able to scan, calibrate, set tilt, restore L2/L7, update
configuration file, update firmware, get MIRCU information, set device data and self-
test.
When 1
st
primary is scanning, if 2
nd
primary send command to MIRCU, the impact on
the 1
st
primary is shown in table below: