User's Manual

MIRCU User Manual
© Comba Telecom Ltd. All Rights Reserved Page 15 of 24
2
nd
Primary Action If MIRCU Support
Impact
on 1
st
Primary
Scan Support No
Impact
Calibration Return “IncorrectState” No
Impact
Set Tilt Return “IncorrectState” No
Impact
ResetPort Support No
Impact
ResetALD Support Broken
Link
Upload File Return “IncorrectState” No
Impact
Download File Return “IncorrectState” No
Impact
MALD Configure Return “IncorrectState” No
Impact
PING Return “IncorrectState” No
Impact
6 MIRCU Installation and Connection
6.1 Installation Requirement
6.1.1 Control Cable Requirement
 Control Cable connector:
Meet the requirements of IEC60130-9 8-pin connector. End of cable are composition
of Male and Female Connectors, connector and cable core meet the AISG interface
standard requirements.
 Cable:
Composition of 5 core with metal and plastic protective layer shielding cable, core
diameter requirements: 3 × 0.75mm + 2 × 0.32mm.
 Protection class:
IP65
6.1.2 Power Supply
MIRCU Input Power: DC +10 V ~ +30 V