User's Manual

MIRCU User Manual
© Comba Telecom Ltd. All Rights Reserved Page 14 of 24
The file download command starts with ‘DownloadStart’ and ends with ‘DownloadEnd’.
The file is carried and downloaded by using ‘DownloadFile’ command. The supported
file types are FirmwareFile and ConfigureFile. The module does not support multi-
ports file download operation simultaneously, which mean when 1
st
primary is
performing download, the 2
nd
primary ports will be close and no operation can be
performed.
g) MALD Configure
When MALD configuration is performed on the module, the access authority of the
module port to each of the subunit of the antenna can be configured. When MALD
configuration operation is performed on the 1
st
primary, the 2
nd
primary will be in
‘Restricted Connection State’.
When 1
st
primary is configuring MALD, if 2
nd
primary send command to MIRCU, the
impact on the 1
st
primary is shown in table below:
2
nd
Primary Action If MIRCU Support Impact on 1
st
Primary
Scan Support No Impact
Calibration Return “IncorrectState” No Impact
Set Tilt Return “IncorrectState” No Impact
ResetPort Support No Impact
ResetALD Support Broken Link
Upload File Return “IncorrectState” No Impact
Download File Return “IncorrectState” No Impact
MALD Configure Return “IncorrectState” No Impact
PING Return “IncorrectState” No Impact
h) Ping
When 1
st
primary is performing PING operation, the 2
nd
primary will be in ‘Restricted
Connection State’. Please refer to AISG3.0 protocol for details PING operation.
When 1
st
primary is performing ping, if 2
nd
primary send command to MIRCU, the
impact on the 1
st
primary is shown in table below: