User's Manual

MIRCU User Manual
© Comba Telecom Ltd. All Rights Reserved Page 11 of 24
2
nd
Primary Action If MIRCU Support Impact on 1
st
Primary
Scan Support No Impact
Calibration Support No Impact
Set Tilt Support No Impact
L2 /L7 Restoration Support No Impact
Update Configuration File Support Broken Link
Update Firmware Support Broken Link
Get Information Support No Impact
Set Device Data Support No Impact
Self-test Support No Impact
5.3.2 Operation in AISG3.0 Mode
A summary of operation conflict for 2 primaries (1
st
& 2
nd
Primary) operating MIRCU-S24 is
shown in table below:
**Note: All “√” and “X” shown are mainly in connection to the 2
nd
primary, which implies
whether or not the corresponding action (listed horizontally in table) can be performed on
the 2
nd
primary when the 1
st
primary is executing a certain command or action (listed
vertically in table). The order of priority of the “primary” is not fix and it is depending on which
primary actually starts an action 1
st
.
2
nd
Primary
1
st
Primary
Scan
Calibrati
on
Set Tilt
Reset
Port
Reset
ALD
Upload
Downloa
d
MALD
Configur
e
Ping
Scan
√ √ √ √ √ √ √ √ √
Calibration √ X X √ √ X X X X
Set Tilt √ X X √ √ X X X X
ResetPort
√ √ √ √ √ √ √ √ √
ResetALD X X X X X X X X X
Upload √ X X √ √ X X X X
Download X X X X X X X X X
MALD Configure
√
X X
√ √
X X X X
Ping √ X X √ √ X X X X
X ： Note 1) MIRCU cannot operate the commands from 2 respective primaries simultaneously.
It conflicts each other and doesn’t comply with AISG standard.