User's Manual

INSTALLATION GUIDE FOR RX-7W22
ENU STATUS : 1-0-2
Copyright - refer to title page
Page 19
5.2.6 [DEVICE PARAMETERS]
Figure 9: Device Info
• Frequency: set the pilot signal frequency from 902-928MHz, default is 910MHz, user can change the
frequency if there is interferences from 900MHz
• OutputPower: Set the output power in dBm for the pilot signal, default is 30 (dBm)
• PowerAmplifier: Manually turn on or off the power amplifier
• Query Cycle: Set the pulse rate for the pilot signal, minimum pulse rate is 3 minutes
• Auto Query: Turn on or off the auto Query
End of Section