User's Manual

USER MANUAL FOR TC-2000
TC-2000 QI
Copyright - refer to title page
Page 26
ENU Status : 1-1-1
Figure 27: Channel Alarm
Figure 28: Fan Alarm
Config:
Tick the check box of [Item select] and [Enable] of the desired parameters and click [config] button to finish
configuration operation.
Notice: [Enable] box
is to enable the alarm monitoring for system. Only if users enable the alarm by
ticking the [Enable] box, the alarms can be monitored by the OMT/OMC.
On the MCU, if any alarm is generated and this alarm is also enabled in [Enable] box, LED ALM turns
RED; while it is OFF when normal working. On the OMT/OMC window, [Alarm Status] indicator keeps
GREEN if no alarm and turns RED if an alarm is generated.
Alarm report can be set, users can allow or prohit the report. When alarm happens, if it is already inquired,
alarm will not report; if not, alarm will dial up to OMC automatically in the mode of SMS or datalink till OMC
receive the alarm and reply; if the device hasn’t received and replyed, then wait 3min and redial to OMC 3
times continuously, if still no reponse, report again after 3 hours.