User's Manual

RS- 5180CDMA800/1900 Dual Band Indoor Fiber Optic
Repeater
Comba Telecom
Edition
2.0
Date
2001-06 18 of 31

B

Installed on the wall support:

1

For the convenience of marking the fixing holes on wall, first
assemble a baseplate and two wall support as shown in the
Repeating End Installation Schematic Diagram (B) (figure 3.1- 5)
to form the baseplate-wall support component. The baseplate
should be removed from the well-assembled portable frame.
Note: Put the portable frame with baseplate removed
horizontally on the ground, not vertically, to ensure safety.
 2 Choose an appropriate place on wall. Move the above mentione d
baseplate-wall support component to the place and mark the
positions of 2 φ 14 holes at both sides.
 3 Drill 4 holes at the four positions with electric impact drill and
embed four φ10x80mm expansion screws.
 4 Lift the baseplate- wall support component. Place it stably on
the wall through the 4 holes using flat gasket, spring washer
and nuts.
 5 Remove the baseplate of the baseplate-wall support component.
 6 Assemble the portable frame as the description about the
assembly of portable frame.

7

Lift the portal frame. Place it stably on the wall support through
the 4 holes on two baseplates and 2 wall supports with
hexagonal M10 screws, flat gasket, spring washer and nuts.
Portal frame is installed well.