User Manual

USER MANUAL FOR COMFLEX 6100
ENU STATUS : 1-0-0
Copyright - refer to title page
Page 59
Click to set band related information.
Figure 78: MU Frequency Band Table
Three parameters need to be set in this step.
 Operator Info: record the operator information of this RU unit.
 RF Switch: Set the RF switch status of this RF unit.
 DL Input Power: Input Power of the BTS signal access to this RF unit. Note: ComFlex system
reaches its rated output power when input power is +10dBm, if DL Input Power is over 10dBm,
software will autoadjust the internal attenuator to make RU output power reach rated Power. (Input
power range: 10-30dBm).
Step 7: Click to enter to RU Setup page after finishing MU setup.
Figure 79: Commissioning Procedure – RU Setup
Click to set band related information of RU.