User Manual

USER MANUAL FOR COMFLEX 6100
ENU STATUS : 1-0-0
Copyright - refer to title page
Page 44
5.2.3 [FIRMWARE]
There are three functions on the [Firmware] bar: [Monitoring Upgrade], [Swap] and [Module Upgrade].
[Monitoring Upgrade] is used to upgrade MCU software, [Swap] is to replace current MCU firmware
version to the previous one, [Module Upgrade] is to upgrade software of each module.
Follow steps shown in below figure to upgrade MCU firmware.
Figure 49: [Firmware] Screen – Modnitoring Upgade
Step 4: After clicking , a window will pop up and click .
Figure 50: [Firmware] Screen – Pop-up Window 1
Step 5: Wait for 2~4 minutes while MU/RU is being reset.
Step1：select
device
Step2：Click to
select software that
to be updated
Step3：Click to
upgrade software