User Manual

USER MANUAL FOR COMFLEX 6100
ENU STATUS : 1-0-0
Copyright - refer to title page
Page 41
Figure 43: MU Device - Optical Unit
Note: MU transmit optical power is -4~-2dBm.
RF Unit Management Screen
Figure 44: MU Device - RF Unit
Remote Unit Management Screen
Click RU photo, users can visit RU directly. Make sure two steps are done before visit RU:
 RU and MU are connected by optical fiber.
 RU device scanning is done. Note: Go to [Commissioning] page or [Management] page for device
scanning.
FOU port number
Optical loss between MU and
RU, the value is over 15dB
when MU and RU are not
connected well
Optical power alarm. Alarm is triggered
when optical power is less than -10dBm.
Indicator will turn from green to red
Click here to
enable/disable optical
RX/TX alarm
Slot number
Commissioning
and calibration
status
Downlink input
power
overdrive alarm
Click here to on/off
RF switch and
modify attenuator
Band and
operator
information of
RFU
RF parameter