User Manual
Table Of Contents
- RF500 LITE System Components
- Safety Information
- RF500 LITE Wireless Monitoring System Overview
- Equipment Installation
- Powering On and Off
- Gateway Commissioning
- Gateway Programming and Use
- Gateway Specification – RF500 LITE
- Transmitters Specification – RF512, RF513 and RF516
- Changing Lithium Battery on RF512 Series Transmitters
- Pinout and Wiring
- FCC Approvals
- Equipment Ratings
- Maintenance and Cleaning
- Declaration of Conformity
- Transmitter Error Codes
- Gateway Fault Conditions
- Definitions of Gateway Terminology
- Glossary
- Document Revision History
Gateway Relay Outputs
The two relay outputs each accept a 2.5mm jack plug. These are individually controlled SPST
relay contacts. Comark provide 2 jack plugs for wiring external equipment to be activated by
the Gateway.
Ensure that any external equipment presents only a low voltage on the jack so as to
prevent any chance of personal injury due to electric shock should the jack plug
become disconnected.
FCC Approvals
This device complies with Part 15 of the FCC Rules. Operation is subject to the following three
conditions:
• This device may not cause harmful interference, and
• This device must accept any interference received, including interference that may cause
undesired operation.
• To reduce potential radio interference to other users, the antenna type and its gain should
be so chosen that the equivalent isotropic radiated power (e.i.r.p.) is not more than that
permitted for successful communication.
Transmitters must be placed greater than 20cm from the body.