Operating Instructions and Installation Instructions

CSB200 Class B AIS

R2.0 11

Data Connection

If an external display unit is to be used to show other AIS units within

range (such as a chart plotter, PC serial terminal or other display device)

connect the user end of the data interface cable to the display device.

Note that the software in the display device must be configured for AIS

operation .

There is a 9-way D-type female connector mounted at the rear of the

CSB200. The standard wire ended data cable assembly provided mates

with this connector.

9 Pin D Cable Colour Signal Name

1 BROWN -NMEA Output (RS422)

2 RED +RS232 Output

3 ORANGE +RS232 Input

4 YELLOW +NMEA Output (RS422)

5 GREEN Ground

6 BLUE Configurable Switch +

7 VIOLET Not Used

8 GREY +NMEA Input (RS422)

9 BLACK -NMEA Input (RS422)

CSB200 Class B AIS

R2.0 12

Connections to a PC.

Connections to a Plotter.

CSB200 Plotter/Radar

1 – Brown- NMEA Output B NMEA Input B- Return

4 – Yellow NMEA Output A NMEA Input A - Positive

Data

The default baud rate of the data link is 38.4kBaud with 8 data bits, one

stop bit and no parity. No handshaking is used.

The data interface conforms to IEC 61162-1.

VDM, VDO, RMC, ACA, ACS, ALR, TXT and ACK messages conform to

NMEA 0183. Please refer to the SERIAL DATA INTERFACE section of

this manual for full details of these AIS messages.

CSB200 PC 9 Pin Serial Port

2- Red -TX Data 2- RX Data

3- Orange- RX Data 3- Transmit Data

5 –Green-Ground 5 -Ground