Technical data

MAINTENANCE PROCEDURES

ADJUSTMENT OF SIDE BRUSH

The regulation of the brush pressure on the floor can be made by adjusting

the screw behind the brush arm itself:

1. Loosen the lock nut (1).

2. Rotate the register screw counter clockwise until the bristles rest on the

floor by about 2 cm.

SIDE BRUSH REPLACEMENT

1. Unscrew the brush fixing knob. Remove the brush paying attention not

to lose the washer and the knob.

2. Grease the shaft.

3. Insert the new brush by putting the key into its place. Reassemble the

washer and the knob.

ADJUSTMENT OF CENTRAL BROOM

To ad just loosen the knob (1) and position the lever (2) in the following

eyelets (3).

Make the same adjustment on the opposite side.

During adjustment follow the broom alignment.

CENTRAL BROOM REPLACEMENT

1. Unscrew and remove all the knobs (1) shown in the picture, and take

out the brush support group (2).

2. Remove the worn broom and insert the new broom.

ATTENTION: keep the same sense of direction of the bristles.

3. Reassemble the support group and the knobs in reverse order.

FLAP RUBBER REPLACEMENT

1. Unscrew the fixing bolts (1) and slip off the blade (2).

2. Extract the weared rubber (3) and replace it with a new one.

3. Reassemble the blade and the fixing bolts.

2 3