Technical data

WORK

BRAKE OR EMERGENCY BRAKE USAGE

Operating on the lever (1) you operate to brake or stop the machine speed.

To stop completely the gear press and push back the pedal until it stops.

To unblock the lever push forward and lift the foot.

Block the brake lever in case of parking or parking on sloping surface.

FLAP USAGE

Operating on the lever (1) you operate to open the flap. Push the pedal

when there is bulky debris in order to allow its entry and collection into the

central broom. Do not keep the pedal pressed.

HOPPER EMPTYING

Periodically check the level of debris in the hopper and eventually empty it.

Keep in mind that the weight of the collected waste is proportionate to the

specific weight of the swept material. In case of heavy material such as

sand, piece of soil, gravel, etc. we suggest you do not fill up the hopper

more than about 70% otherwise emptying could prove difficult.

To dump the hopper from the machine proceed as follows:

1. Dump the hopper from the machine rotating clockwise the lever (1) until

to free the hinge pin (4)

2. Transport it to a dump area by using the handle (2) and dump it.

3. Check that the gasket of the hopper (3) is clean so that it guarantees a

good tightness.

3. To assemble again the hopper insert the edge into the two supports (5).

4. Lift the hopper until it is perfectly on the gasket (3) on the bodywork of

the machine.

5. Rotate clockwise the lever (1) until to hook to the hinge pin (4) of the

hopper.

AT THE END OF USE

1. Stop the machine.

2. Apply the parking brake.

3. Activate the filter shaker.

4. Dump the debris hopper.

5. Switch off the machine by turning the key to the OFF position.