Specifications

PATHWORKS Native Datalink Installation

To install the DLLEWRK3.EXE ﬁle, use the following procedure:

1. Enter NICSETUP to change the Turbo board conﬁguration from

2K mode (the default) to 32K or 64K mode.

2. If you are using an Extended Memory Manager, ensure that the

board memory range is excluded (for example, x=D000-D7FF).

3. For users of PATHWORKS version 4.1 or earlier, run NETSETUP

to automate the Native Datalink driver installation. Select the

EtherWORKS Native Datalink as the Ethernet adapter type.

4. After NETSETUP completes, change the

%BOOT%\dlldepca.exe

line in STARTNET.BAT to

%BOOT%\decnet\dllewrk3.exe

5. Once this change is complete, copy the DLLEWRK3.EXE driver

from the distribution diskette \PATHWRKS directory to the

\DECNET directory on your hard drive.

6. For users of PATHWORKS version 5.0 or later, select the

EtherWORKS 3 Native Datalink menu option during NETSETUP

to automate the installation.

Note

Unlike the Native Datalink driver for earlier EtherWORKS

products, DLLEWRK3 does not require changing the command

line. If you need to alter the Turbo board conﬁguration

parameters, execute the NICSETUP utility included on the

board distribution diskette. When the DLLEWRK3 driver

is invoked, it will automatically read the board’s internal

settings.

4–8