Specifications

EISA Configuration
When the Turbo board is used as an EISA device in an EISA system,
the boards’ EISA configuration files are used in conjunction with your
system EISA Configuration Utility (ECU) to configure the board.
The following EISA configuration files are located in the \EISA
directory on the Turbo distribution diskette:
• !DEC2030.CFG for use with the DE203-AA or -AB Turbo board
• !DEC2040.CFG for use with the DE204-AB (only) Turbo board
• !DEC2050.CFG for use with the DE205-AA or -AB Turbo board
EISA Mode Setup
This section describes how to set up your Turbo board configuration
prior to running your system ECU software.
To set up the Turbo board for EISA mode, perform the following
procedure:
1. Install the Turbo board in an EISA system.
2. Insert the Turbo distribution diskette into the PC disk drive and
set the default directory to the drive being used (for example,
drive A).
3. Type NICSETUP at the DOS system prompt, then follow the screen
instructions to display the Main Menu.
4. Select the Setup option, then press Enter twice to display the
User Selected Value screen. The I/O base address (for example,
300H) is highlighted. Press Enter again to display a list of the
system I/O addresses.
5. Use the down-arrow key to scroll to the EISA mode option (bottom
of list), then press Enter . Note that the I/O base now reads
I/O Base = EISA.
3–6