Specifications

Note
The Setup utility is based on DOS. If you are using another
operating system, you need to boot your system from a DOS-
based diskette and complete the Setup. Then, reboot the
system to the operating system of your choice.
Accessing the Setup/Diagnostic Utility
To access the Setup/Diagnostics utility:
1. Insert the Digital EtherWORKS 3 Turbo distribution diskette into
the disk drive.
2. Set the system to the disk drive being used.
3. Type NICSETUP at the DOS prompt.
An introductory window appears. Follow the instructions on each
succeeding screen to set up the Turbo board.
Setup Conventions
The Turbo Setup/Diagnostic utility uses the conventions listed in
Table 3–1.
Table 3–1 Setup/Diagnostic Conventions
If you want to . . . Then . . .
Select an option or menu Highlight the option or menu and press
Enter .
Return to the previous window Press Esc .
Move from one selection to
another
Use the arrow keys.
Help on any option or menu item is always available while using the
Setup utility.
3–2