Specifications

Resolving BUS Conﬂicts on ISA and EISA

Systems

Once you have installed the Turbo board, you are ready to turn on the

system and begin the setup and software device driver installation.

The Turbo board is shipped with the following pre-programmed

factory-default settings:

• Memory address: D0000h - D07FFh (2-KB mode)

• I/O Base address: 300h

• Interrupt value: 5

If a setting conﬂicts with a resource in the system, the system may

not operate correctly. If this occurs, you may need to use jumpers to

cover either the W1 and/or W2 posts to override the factory default

settings. (This is called a "hardstrap override.")

Table 2–2 lists the available jumper selections. Figure 2–6 shows the

factory-default (Out position) default jumper settings

for W1 and

W2 on the Turbo, Turbo TP, and Turbo PLUS boards.

Note

If a hardstrap override does not resolve the system conﬂict,

contact your local Digital Service Representative.

2–10