Specifications

Preparing your PC
To prepare your PC for installing the Turbo board, perform the
following procedure.
Caution
Static electricity can damage printed circuit boards and
chips. It is strongly recommended that you use a grounded
wrist strap and grounded work-surface-to-earth ground when
working with these components.
1. Remove any diskettes from the diskette drives.
2. Set all power switches to O (off).
3. Unplug the power cord from the wall socket, then disconnect the
cord from the rear of the system unit.
4. Unplug the keyboard connector from the rear of the system unit.
5. Disconnect any option cables and the monitor cable from the rear
of the system unit.
Note
Note where the cables are connected, so you can reconnect
them correctly.
2–2