coM.
User Manual coM.sat PCI GSM Index Index .................................................................... 1 1. Introduction ................................................... 2 1.1 1.2 1.3 1.4 Equipment description ................................................................................................ 2 Feature survey ............................................................................................................. 2 Technical requirements .......................................
User Manual 1. coM.sat PCI GSM Introduction 1.1 Equipment description The coM.sat PCI GSM-Board is meant to serve as an interfacing tool for the GSMnetwork, that gets your software-based telephone system ready for GSM. The coM.sat PCI GSM-Board is aligned with Linux OS and offers a kernel-independent driver as well as a channel driver for Asterisk, already included in the scope of supply.
User Manual coM.sat PCI GSM 1.4 Security advice for user The users are explicitly requested to read and assimilate the item security advice for users. The following advices refer to the equipment coM.sat PCI GSM. As this equipment uses components of the company Cinterion (Cellular Engines MC55i) also their security advice as well as instruction manuals have to be considered. Visit www.cinterion.com 1.4.
User Manual coM.sat PCI GSM 1.4.7 Transportation The packaging provided by deliverer when receiving the equipment does not guarantee full protection against crushing and beating during transportation. Therefore an additional packaging should be provided for further transportation. In case the equipment was stored within a cold environment, it should slowly be warmed up until it reaches ambient temperature, in order to avoid humidity issues. 1.4.
User Manual 2. coM.sat PCI GSM Installation of the PCI Board Before beginning with the installation, turn off the computer, unplug its network cable and open its case. In order to install the coM.sat PCI GSM Board an available PCI slot is needed. 1. Choose an available PCI Slot and remove (if necessary) its Slot bracket. 2. Insert the coM.sat PCI GSM Board with light pressure into the empty PCI slot. 3. Fix the Board with the screws. 4. Close the case and plug in the network cable. Created on: 18.01.
User Manual 3. coM.sat PCI GSM Upgrading of the PCI Board to 4 channels To upgrade the coM.sat PCI GSM Board first you will have to remove it from your computer. Before doing so, turn the computer off, unplug its network cable and open the case. Then move on as follows: 1. Unscrew the screws that fix the coM.sat PCI GSM Board and slowly remove it from the slot it is placed in. 2. Connect the antenna cable with the available antenna connection by pressing the cable into it with light pressure. 3.
User Manual coM.sat PCI GSM 5. ... until about 1,5 mm of the contacts can still be seen. 6. Insert the board back into the PCI slot and fix it with the screws. Close the case and re-plug the network cable. 4. Getting the PCI Board into operation To start operation of the coM.sat PCI GSM Board first you will have to insert the SIM-cards and connect the antenna. 1. With a pen or a small screwdriver press onto the yellow button to eject the SIM-cardholder. 2.
User Manual coM.sat PCI GSM Remark: In case you are in possession of a 2-channel-version of the coM.sat PCI GSM Board you will have to use one of the lower two SIM-card ports „1“ and „2“. Also only one antenna will be necessary and it has to be connected to the connection marked with„ ½“! In case you purchased the 4-channel version you can/will have to use all 4 SIM-card ports. This will require the connection of a second antenna. 5. Technical data of the PCI Board Power input max.
