User`s guide

Configuring TCP/IP 9
k. Your modem will now begin the auto-acquisition process. Refer to “LED
Acquisition States” on page 13 for details.
Now that you have connected the PC and the DOXport 1110, perform the
following step:
6. Configure the network parameters of your computer based on the instructions
provided by your cable operator. Refer to “Configuring TCP/IP” on page 9 and
“Verifying Your IP Address” on page 12 for information on how to configure
TCP/IP and check your IP address in Windows.
Configuring TCP/IP
With the modem connected, make sure that you have your computer configured for TCP/IP
and check for an IP address. The following instructions are for Windows 98 using Ethernet. If
you are using a different operating system, or computer interface, refer to that system’s user’s
guide.
Perform the following steps:
1. On the Windows desktop, click Start.
2. Select Settings and then Control Panel from the pop-up menu. Double-click
the Network icon on the Control Panel window. The Network window
appears, as shown in Figure 12.
Figure 12.
Network Window