User`s guide

6 DOXport 1110 User’s Guide
e. Reboot the computer when the installation is finished.
— Click START -> SHUT DOWN -> RESTART.
f. Your modem will now begin the auto-acquisition process. Refer to “LED
Acquisition States” on page 13.
g. Go to step 6 on page 9.
Using your Windows 98/Me/2000 computer’s USB port (manual procedure):
a. Plug the rectangular-end of the USB cable into your computer’s
USB port, and the square-end of the USB cable
into the USB port of
the DOXport 1110 (labeled “USB”
).
b. Once the USB cable is connected, the computer will detect the newly
added USB device and prompt for the USB driver installation. Click OK
to begin the installation.
c. Follow the on-screen prompt instructions and enter the drive letter of the
DOXport 1110 Reference CD-ROM, on which the USB device driver and
support driver are located.
d. After the networking device driver is installed, the networking support
driver is also needed. Follow the on-screen prompt to complete the
installation.
e. Click Next to the next prompt
o
Figure 7.
Add New Hardware Wizard