User Manual

· Gently remove the water bucket from the dehumidifier by gripping both top and bottom sides and

pulling outward;

· Open the drain outlet lid on the bucket cover and then empty the bucket;

· Replace the water bucket to the dehumidifier. The dehumidifier will auto eliminate the E7 error

and resume operation in 1-3 minutes after the water bucket been replaced properly.

2) Continuous Drain by Gravity

Water can be automatically be emptied into a floor drain by attaching the included drain hose.

NOTE: You can use any other hoses with inner diameter of 5/8 (0.63) inches instead.

To Achieve Continuous Drain by Gravity:

· Remove the plastic cover from the continuous drain outlet;

· Remove the water bucket;

· Attach the included drain hose to the drain outlet;

· Replace the water bucket to the dehumidifier properly;

· Direct the other end of the drain hose down to a suitable drainage facility, like a bigger external

bucket or floor drain. The drainage facility should be lower than the drain outlet of the dehumidifier.

Note:

- Make sure the connection is tight and there is no leaking.

If there is a small leak at the drain outlet, then try to connect the other end of the hose to the outlet,