Service manual

12
in.xe
Installing the in.k200
The keypad should be installed directly onto the spa (or very
close to it) so that it is easily accessible to the user.
• To install the in.k200, drill two 1” (25 mm) diameter holes at
2 5/8” (67 mm) from center to center as illustrated.
• Cut out the material between the two holes (see illustration).
• Clean the installation surface and peel the adhesive gasket from
the back of the keypad.
• Insert keypad and align it correctly, then ensure it's properly
glued by gently pressing evenly on the entire surface.
2
5/8
"
∅ 1"
Gasket with adhesive
1"
2 5/8"
66 mm
∅ 1"
25,4 mm
∅ 1"
25,4 mm
1" dia. drill
Keypad installation & connections