Manual

A I
TO UNLOAD REVOLVERS WITHOUT EJECTOR RODS I
ill CAUTION: ALWAYS EXCERCISE EXTREME CARE TO KEEP MUZ-
ZLE POINTING IN A SAFE DIRECTION, WELL CLEAR OF YOUR
BODY, PARTICULARLY WHEN UNLOADING REVOLVERS THAT DO
NOT HAVE EJECTOR RODS.
1. Be sure you are familiar with Safety Instructions in Section 3. KEEP
REVOLVER POINTING IN SAFE DIRECTION AND DO NOT TOUCH
TRIGGER.
2. Draw hammer back to Half-Cock position. (The cylinder is now free to
rotate clockwise.)
3. Open loading gate.
4. KEEP FINGERS AWAY FROM TRIGGER, align chamber as shown
in Figure 8, tilt revolver muzzle up and remove cartridge as it slides back
out of the chamber.
5. Rotate cylinder clockwise to align next chamber and repeat step 4
above; repeat until all chambers are empty.
NOTE: If cartridges or spent cases cannot be removed as described in
steps 4 and 5, remove the cylinder as follows and use the base pin to
push out the remaining rounds. See Figure 12.
a. KEEP MUZZLE POINTING IN A SAFE DIRECTION WELL CLEAR
OF YOUR BODY AND depress base pin retaining catch to release
base pin. On Blackpowder frame revolvers use a properly fitting
screwdriver to remove the base pin retaining screw.
b. Remove base pin.
@
SAFETY DEPENDS ON YOU