Manual

revolver. Release retaining catch.

NOTE: Blackpowder frame re-

volvers have a base pin retaining

screw in front of the frame which

must be removed before base

pin can be removed.

c. Carefully remove cylinder to

the right of frame and avoid con-

I - -

tact between the ratchet and

loading gate.

RATCHET

FIGURE 128.

CYLINDER REMOVAL

IMPORTANT: Do not strip your revolver further than removing the cy-

linder. If later additional maintenance is required see "Servicing and

Repair" later in this instruction manual.

ASSEMBLING AFTER CLEANING

NOTE. Assemble in reverse order. With hammer at half-cock care-

fully install the cylinder by rolling it into the frame from the right side.

Install and secure the base pin. Check that the cylinder rotates freely.

Lower hammer to safety position and close the gate.

WHEN TO CLEAN

You should clean your revolver as soon after firing as possible so that

the job will be easier and there will be less opportunity for corrosion to

start. When your revolver has not be fired, clean it periodically; we

SAFETY DEPENDS ON YOU