Manual

IMPORTANT: If you cock your revolver but do not fire it, retum
hammer to Safety position by placing thumb firmly on hammer
spur and draw hammer back slightly to disengage Cocked notch.
Squeeze trigger only long enough to allow hammer to move
forward and clear Cocked notch, then release trigger completely.
Half.Cock notch will then be engaged and cylinder must be
rotated until empty chamber is in front of hammer. Draw hammer
back slightly to disengage halt-cock notch. Squeeze trigger only
long enough to allow hammer to move forward and clear halt-
cock notch, then release trigger completely so that safety notch
can be properly engaged.
"
you lose the opportunity to fire,
unload your revolver as previously described.
&'CAUTION: IF YOU DO NOT RELEASE TRIGGER FULLY
BEFORE REACHING SAFETY POSmON, SAFETY NOTCH
MAY NOT BECOME FULLY ENGAGED, rendering ItIneffective
as a safety device.
SAFETY DEPENDS ON YOU
@