Operators Safety & Instruction Manual

Detailed Cleaning Techniques [cont]
• Apply CLP or oil to the trigger mechanism, selector, magazine catch, pivot and takedown pins, detents,
and buttstock lever.
• Clean and lightly apply CLP or oil to the inside of the buffer tube, buffer, and buffer spring.
COMPLETION OF CLEANING PROCEDURES
• Wipe all components clean and dry, and inspect for excessive wear, corrosion, or mechanical damage.
If any are discovered, have them corrected before firing again.
• Re-assemble the firearm.
• Remove any gun cleaning solution, oil, and finger prints from the outside surfaces of the firearm.
Moisture from fingers, if left, could start the corrosion process.
Securing and Storing Your Firearm
• Make certain your firearm is safe and secure by following all applicable laws pertaining to the storage
of your specific firearm.
• ALWAYS store your firearm UNLOADED.
• ALWAYS store your firearm UNCOCKED.
• Store ammunition in a separate, secure location from your firearm.
• Lightly coat the outside of the firearm with CLP or oil.
• If storing for a long period of time to avoid corrosion, apply CLP or oil to a swab and pass it through
the barrel, beginning from the chamber down to and out the muzzle. Clean the CLP or oil out of the
barrel before firing again.
NOTE
34
17274S-EN