Operators Safety & Instruction Manual

25
17274S-EN
Additional Stripping [Refer to Figure 8 & 9 pgs. 25 & 26]
• Using a suitable punch, remove
the extractor pin [1].
• Remove the extractor and spring
as an assembly: DO NOT
separate the spring from the
extractor and DO NOT remove
the elastomeric insert (black
rubber) from inside the extractor
spring. Ensure that the “D-ring”
elastomer [2] is present in the
spring group.
• Push the receiver pivot pin [3] all
the way to the right.
• Separate the upper and lower
receivers.
• Press in on the buffer [4],
depress the buffer retainer [5],
and release the buffer under
control.
• Remove the buffer and return
spring [6].
Figure 8