Operators Safety & Instruction Manual

17
17274S-EN
Loading the Firearm [cont]
NEVER LEAVE YOUR FIREARM COCKED AND LOADED WITHOUT THE SELECTOR IN
THE “S” POSITION. THE FIREARM COULD EASILY BE FIRED OR DISCHARGE CAUSING
DEATH, INJURY OR DAMAGE TO PROPERTY.
• Close the ejection port if you wish. This will open automatically after the first round is fired.
Unloading the Firearm
[See Figure 1 pg. 10]
• Ensure that the fire control selector [5] is set to [S].
• Depress the magazine release [1] and remove the magazine [2].
• Pull the charging handle [3] fully rearward, then hold it to the rear.
• Check to ensure that the receiver and chamber are clear.
• Allow the bolt carrier group to go forward under control.
• Set the fire control selector to [R] and squeeze the trigger [4] to “Fire” the action.
• Close the ejection port.
• Take control of any ejected cartridges and return them to the magazine.
Firing Your Diemaco MRR
IF YOU NOTICE A DIFFERENCE IN SOUND OR RECOIL: STOP FIRING! THERE COULD BE
A BULLET LODGED IN THE BORE. FIRING THE FIREARM WITH A BULLET LODGED IN
THE BORE COULD CAUSE A BREECH EXPLOSION AND INJURY TO THE OPERATOR.
WARNING
WARNING