Operators Safety & Instruction Manual

17274S-EN

Use of the charging handle will cock the action.

While holding the charging handle to the rear, the bolt carrier group can be locked to the rear

by depressing the bottom of the bolt catch [6]. The charging handle can then be returned

fully forward. This may be desirable for inspection during range procedures. Be sure to set

the fire control selector [5] to [S] once locked open.

• Look in through the ejection port and check to ensure that the receiver and chamber are clear.

• Allow the bolt carrier group to go forward under control.

• Set the fire control selector to [R]

and squeeze the trigger [4] to “Fire” the

action.

• Take control of any ejected cartridges

and return them to the magazine.

If you have locked the bolt

carrier group to the rear, unlock

it by pulling the charging

handle fully rearward before

allowing it to go forward under

control.

NOTE

Figure 1