Manual

I
Magazine For Most Other Calibers
I
(See Figure 17)
To remove this magazine follower and spring, depress them with a piece of
wood (pen or pencil) about two inches into the magazine and insert a thin rod
(small screwdriver) through the lower of the front two holes in the magazine
body. This will hold the spring under tension.
Turn the magazine upside down and lightly tap it so that the follower falls away
from the spring; lift out the follower from the magazine body. Push down on the
spring to take up the spring tension, remove the thin rod and allow the spring to
extend, then remove it completely.
To assemble this magazine, place the spring correctly oriented, i.e. with loop
uppermost pointing forward into the magazine body, compress the spring and
insert a thin rod as for dismantling. Place the follower in the magazine take up
the spring tension, remove the thin rod and allow the spring to reassert its
influence on the follower.
@)
SAFETY DEPENDS ON YOU