Manual

4. (A, B & C) Cock the hammer.
Look at the top of the receiver and
make sure the plunger lever is down
(forward), tip the receiver forward to
keep it down as you run the slide
onto the receiver; (See Figure 14).
Look through the slide stop hole in
the side of the receiver. Move the
slide along the receiver until you
see the hole in the barrel link line up
with the hole in the side of the
receiver. Insert the slide stop
through the hole until it is almost
home; (See Figure 15).
Continue pushing the slide rearward
until the disassembly notch lines up
with the rear part of the slide stop.
Now push the slide stop up and in
against the slide stop plunger until
the slide stop is fully home.
@
FIGURE 14-INSTALLING SLIDE
FIGURE 15-INSTALLING SLIDE STOP
SAFETY DEPENDS ON YOU