Operator's Manual

SAFETY DEPENDS ON YOU
- 27 -
AIMING AND FIRING (Cont.)
b. Single Action Mode- After aligning the target and sights, with finger outside the trigger guard,
draw the hammer fully back to the cocked position (Figure 13) where it will be held by the
sear. Remove thumb or finger from hammer spur and place finger inside trigger guard and
gently squeeze trigger until the hammer falls. Repeat procedure until you have completed
firing.
IMPORTANT: Trigger travel and pressure is significantly less in single action mode to fire the revolver.
So it is your responsibility to exercise care in handling the revolver when firing in single action mode.
Figure 13