Operators Safety & Instruction Manual

• ALWAYS check to ensure a firearm is NOT loaded immediately after picking it up.

• NEVER leave a loaded firearm unattended.

• ENSURE that the cam pin is installed in the bolt carrier group. If the cam pin is not

installed, firing the firearm may cause a breech explosion.

• When using blank firing attachment (BFA) use only blank ammunition.

• If the firearm stops firing with a live round in the chamber of a hot barrel “Misfire” remove

the round immediately or wait 15 minutes to avoid injury from a “Cook Off”.

• Do not fire the firearm with water in the barrel. Firing may cause a breech explosion.

• If you notice a difference in sound or recoil: STOP FIRING. Check for a bullet in the

bore. Firing the firearm with a bullet lodged in the bore could cause a breech

explosion.

REMOVE WATER FROM THE BARREL AS FOLLOWS:

• Remove the muzzle cap.

• Pull the cocking handle rearward 5 to 8 cm and allow the water to drain.

• Point the muzzle down and shake firearm vigorously.

• If the next round does NOT fully chamber, press the forward assist plunger with thumb

pressure only to seat the round in the chamber. If the cartridge still will not chamber

thoroughly check bore, chamber and cartridge.

• Clean the drain hole in the extension with a pipe cleaner and drain.

PRECAUTIONS WHEN HANDLING THIS FIREARM

15680S-EN