Operators Safety & Instruction Manual

FUNCTION TEST

Test the function of the firearm after assembly, with the

magazine removed, as follows:

• Cock the firearm; move the fire control selector to “S” and

squeeze the trigger: The hammer should not be released.

• Move the fire control selector to “R”; squeeze the trigger

and hold it to the rear. The hammer should be released.

• With the trigger still at the rear, cock the firearm: the

hammer should not be released.

• Release the trigger and listen for a “Click” as the

disconnect releases the sear.

• Squeeze the trigger again. The hammer should be

released.

FUNCTION OF THE RIFLE/CARBINE [cont]

When the trigger is released, the disconnect is rotated back releasing the hammer. However, before the

hook on the disconnect releases the hammer, the trigger sear surface has rotated in front of the hammer

notch so that the hammer is held on the trigger sear surface in the ready position.

THIS IS A SEMI-AUTOMATIC FIREARM. IT IS IMMEDIATELY LOADED AND READY TO FIRE AFTER

EACH SHOT UNTIL THE MAGAZINE IS EMPTY.

15680S-EN