Manual

&CAUTION: ALWAYS EXERCISE EXTREME CARE TO KEEP
MUZZLE POINTING IN A SAFE DIRECTION, WELL CLEAR OF
YOUR BODY, PARTICULARLY WHEN UNLOADING REVOLVERS
THAT DO NOT HAVE EJECTOR RODS.
1. 8e sure you are familiar with Safety Instruction in Section 3.
KEEP REVOLVER POINTING IN SAFE DIRECTION AND DO NOT
TOUCH TRIGGER.
2. Draw hammer back to Half-Cock position. (The cylinder is now
free to rotate clockwise).
3. Open loading gate.
4. KEEPING FINGERS AWAY FROM TRIGGER, align chamber as
shown in Figure 6 and push ejector rod, (located under the barrel)
backwards through cylinder chamber, forcing out the live round or
empty case, which should be removed from revolver. Allow ejector
rod to return forward under its spring action.
5. Rotate cylinder clockwise to align next chamber with ejector rod
and repeat step 4 above; repeat until all chambers are empty.
6. Close loading gate.
7. With thumb firmly on hammer spur, draw hammer back slightly to
disengage Half-Cock notch. Squeeze trigger only long enough to
allow hammer to move forward and clear Half-Cock notch, then
release trigger completely so that the hammer can be safety
lowered to its fully down position.
@
SAFETY DEPENDS ON YOU