Manual

3. Open loading gate by swinging it out to the right, exposing back
of cylinder and a chamber. Check each of six chambers to ensure
they are clean and free from accumulated oil. (Clean if necessary;
see cleaning instructions).
4. Use only ammunition
recommended on page 3
of this instruction manual
as suitable for your
revolver. Insert a round of
ammunition into chamber.
5. Press round home until
it is fully seated.
6. Rotate cylinder clock-
wise to expose next empty
chamber and insert a
round as in steps 4 and 5
above; repeat until FIVE
rounds are loaded.
& CAUTION: LEAVE ONE
CHAMBER EMPTY FOR
SAFE CARRYING.
& CAUTION: INSURE EMPTY CHAMBER REMAINS IN FRONT OF
HAMMERAND INUNE WITH BARREL, so that if hammer falls forward,
firing pin will not strike live round to cause accidental discharge.
FIGURE 5-LOADING GATE OPEN
SAFETY DEPENDS ON YOU
@