Operating instructions

Blower ”drying heater”
Remove the protective grid of the blower (position 3).
Loosen the nut (position 1).
Loosen and remove the screw (position 2).
Slide motor with carrier flange plate (position 6) towards the carrier flange
housing (position 4).
Tension the V-belts by means of screw (position 2) until the belts (position 5) can
be pressed in by approx. 3 mm (pressure: 25 N).
Tighten the nuts on threaded bolt (position 1) again.
Mount the protective grid of the blower (position 2).
Mount the side panels.
F
Attention should be given to exact alignment of the V-belt
pulleys.
CTT 300
Maintenance 5-11
6 5 4 3
1 2 3