Operating instructions

4.5.3. Entering hopper values
Select ”Hopper” .
Acknowledge with the ENTER-key.
or
Press the ”F4” -key.
Hopper entry X Target
(X = number of the drying hopper)
Enter the drying temperature for hopper flap X (when operating with
supplementary heating).
Acknowledge with the ENTER-key.
Hopper entry X Act.
(X = number of the drying hopper)
The current temperature at the feed opening of hopper flap X will be displayed.
&
If there is a cable break “+0 °C” is displayed.
F
The lowest drying temperature setting of the hopper flap
must be the same as or higher than the drying temperature.
Dehumidified air dryer
Start-up 4-13