Operating instructions

F
If the dryer has not been in use for several months it must be
operated for about 2 hours without material.
Turn the thermo regulator to +80 °C for the drying temperature.
Press the “PGM” key.
Set by means of the arrow keys the drying temperature
to “80".
After 2 seconds the display flashes and the value is stored.
Press the “EXIT” key (the setpoint value and the actual value
of the drying temperature are displayed).
After 2 hours turn the release switch “Timer” at “0" position.
L
Wait until the blower has stopped.
The run on time of the blower is 10 minutes.
If there is a return air cooler installed, switch off its coolant circuit.
Switch off the main switch of the dryer.
&
The green signal lamp goes off.
64.10-0067GB10 06/00
CTT 30
Start up 30
EXIT