Operating instructions

Turn the release switches “Hopper” (TT1, TT2) at “I” position.
Turn the thermo regulator to +80 °C (176 °F) for the drying temperature.
Press the “PGM” key.
Set by means of the arrow keys the drying temperature to “80" (176).
After 2 seconds the display flashes and the value is stored.
Press the “EXIT” key (the setpoint value and the actual value
of the drying temperature are displayed).
After 2 hours turn the release switches “Hopper” (TT1, TT2) at “0” position.
Turn the release switch “Timer” at position:
L
Wait until the blower has stopped.
The run on time of the blower is 10 minutes.
If there is a return air cooler installed, switch off its coolant circuit.
Switch off the main switch of the dryer.
&
The signal lamp “power” goes off.
64.10-0214GB11 07/03
CTT 40 / CTT 70
Start up 3-3
EXIT