Specifications

REFERENCE MANUAL
NSI CORPORATION MC 24/48 Version 1.03
7
[AND]
Location: Hard key, Data Key Pad
Use the [AND] hard key to make a channel list, or to make a split time, split delay or split profile. When
the [AND] key is entered as the first keystroke in the Command Line in the Effects display, channels are
added to an existing step.
& EXAMPLE: To use the [AND] key in the Command Line to address channels and levels:
Channel [1] [AND] [GROUP] [4] [AND] [SUB] [8] [AT] [FL] [ENTER]
@NOTE: The [AND] key on your console may be labeled "AND" on the key itself. In the Command
Line, this keystroke always appears as "+".
[AT]
Location: Hard key, Data Key Pad
Use the [AT] hard key to assign a channel list to a level, or to make a patching assignment. When the
[AT] key is entered first in the Command Line, the command defaults to all captured channels.
& EXAMPLE: To assign a level of 80% to channels 25 - 31 in the Stage, Preview, Group,
Submaster and Tracksheet displays:
Channel [25] [THRU] [31] [AT] [80] [ENTER]
-B-
[BLACKOUT]
Location: Right Console Face, above Grand Master Fader
You can use the Blackout Switch on the console to instantly set channels to zero. When the
[BLACKOUT] Switch is returned to the NORMAL position, the channels return to their previous levels.
The [BLACKOUT] Switch only cuts the output of normal channels; Automated channels with assigned
levels are not affected by the [BLACKOUT] Switch (if you want to set auto-channels to zero, you must
address them directly via keypad or cue).