Specifications

REFERENCE MANUAL
NSI CORPORATION MC 24/48 Version 1.03
18
Setup menu item 2 provides a way to specify a disk file name for the show in current memory. This name
is different from that of the "Show Name" and must follow MS-Dos naming conventions of a maximum of
11 letters. These will appear as "xxxxxxxx.xxx" if the disk directory were viewed on a PC.
& EXAMPLE: To assign a Show Name to a show in the Setup display:
1. Press [2] on the data keypad.
2. Using the Submaster bump buttons or an optional ASCI keyboard enter alphanumeric
show name or any number from the channel keypad, press [ENTER].
@ NOTE: The current release of MC 24/48 software does not allow for off-line editing of Show
information.
[FULL]
You can use the [FULL] hard key in the Command Line to bring channel or dimmer levels to 100%.
"AT" is automatically entered into the Command Line when you press [FULL].
& EXAMPLE: To set a channel level to full:
[#] [FULL] [ENTER]
RELATED TOPICS:
[AT]
-G-
[GROUP]
Location: Data keypad
You can use the [GROUP] hard key on the Data Entry Keypad to recall a pre-recorded assignment of
channels at levels. You can use the Group key also to create a channel list of specified group channels. A
group may be proportionally controlled by calling for a specific group at a level, in which case all channels
in the group read proportionally. All channels in a group may be controlled by an absolute value by
pressing the [GROUP] key twice before specifying the group number.
& EXAMPLE: To recall a group at proportional levels in the Stage, Preview, Submaster, Group,
Effect and Tracksheet displays: