Operating instructions

Colortrac SmartLF Cx 40 Installation and Operating Manual

The Wizard will STOP because the driver is not

recognised by Windows’ logo testing system.

Ignore this and click ‘Continue Anyway’

This is completely normal.

Windows transfers the driver to the scanner

computer. Do not start other applications while

this is happening.

The Hardware Wizard will finish by showing this screen. Click the Finish

button to complete the installation of the SmartLF Cx driver.

The driver is now installed. There is no need to reboot the computer.

NOTE: IF A DIFFERENT COMPUTER USB2 PORT IS USED

WINDOWS WILL CREATE A NEW NUMBERED DRIVER ENTRY IN

THE SYSTEM HARDWARE LISTING

The SmartLF Cx USB driver is now installed. Whenever the scanner is plugged into the computer, Windows will

identify the USB (Universal Serial Bus) device as SmartLF Cx and automatically load this driver. The scanner can

be plugged and disconnected freely like any regular USB device without needing to re-boot the computer.

CHECKING FOR THE SMARTLF DRIVER

The Windows system will allow the operator to check for

correct installation of the driver. Should the driver ever

be accidentally removed or require updating or in the

unlikely event of the user experiencing problems with

SmartLF Cx, this check can be useful.

Using the Windows Control Panel click on the System

Properties icon. From here click the Hardware tab and

look for the Imaging devices entry.

Right clicking on the SmartLF Scanner entry will bring up

the Properties for the device where the status of the

scanner is displayed. The status should be ‘ This device

is working properly’

NOTE: When SmartLF is not connected or not

powered-up ‘SmartLF Cx Scanner’ will NOT be

visible as an Imaging device in the Hardware listing

of the Windows System.





