Operating instructions

Colortrac SmartLF Cx 40 Installation and Operating Manual

7. REMOVING THE SHIPPING PROTECTION AND SETTING UP SMARTLF CX

Before attempting to use SmartLF Cx it is essential that the foam shipping layer which protects the scan glass covers

is removed from inside the scanner:

 Lift the catches on each side of the scanner and then raise the whole lid. Fit the support stay on the left-hand side (circled)

• Remove the piece of foam and retain with the packaging for the scanner (always replace this item when transporting SmartLF)

 While supporting the scanner lid with one hand release and store the stay and then gently lower the lid to close it.

 Fit the three paper support trays by compressing (springing) them into the slots on the back of the scanner (the precise design may vary)

 Connect the scanner to the electricity supply using the localised cable provided

IMPORTANT – DO NOT CONNECT THE SCANNER TO THE COMPUTER UNTIL INSTRUCTED

8. OPENING THE LID OF SMARTLF CX

The SmartLF Cx is a single part lid that provides access to the scanner optics. With the lid in the open position and

safely propped the scanner glasses can be inspected and cleaned if required.

• Always use two hands to open the lid

• Use one hand in the centre of the

lid to steady it while using the

other hand to secure the prop. It

is essential to use the prop when

cleaning or inspecting the

scanner optics for dirt or dust

contamination