User manual

Colortrac Flatbed Installation and Operator Manual.

PAS119

3.3.2 Installation using Ultra-Wide SCSI

The host computer and the scanner should be powered off and an appropriate SCSI

cable used to connect the scanner to the computer. By default the scanner is set to SCSI

ID 5. If your PC is not compatible with this setting please contact your distributor who will

be able to provide assistance.

4 OPERATION OF SCANNER

4.1 Initial Start-Up

On power up the internal scanner lights will turn on and the main display will show a

rotating symbol for approximately 15 seconds. As soon as this symbol disappears, the

scanner is ready for use. The Flatbed 24120 scanner has two cameras and at the initial

installation the unit will require a stitching and calibration check by the installing

engineer/technician. These checks should become part of the regular maintenance

procedure for the scanner. For more details on how to do this please see Section 6 of

this manual.

4.2 Document placement

To carry out a scan lift the cover on top of scanner and lay the document onto the glass

surface face down and lined up with the narrow black edge of glass. Carefully replace the

cover ready for scanning. It is recommended that documents are not left for long periods

inside a powered up scanner to avoid possible light damage from prolonged exposure to

the internal light source.

WARNING - Documents that are sensitive to light

should not be left in the scanner

COLORTRAC LTD ACCEPTS NO LIABILITY FOR DAMAGE TO ANY DOCUMENT

DURING THE LOADING PROCESS OR ACCEPTS NO LIABILITY FOR DAMAGE TO

ANY DOCUMENT FADED BY LIGHT.

NOTE: Cover illustrated may differ from actual product

Lift cover and place document so

that bottom of document is at

edge nearest display panel.