Certifications 2

Page 6/11
Safety data sheet
according to 1907/2006/EC, Article 31
Printing date 30.06.2020 Revision: 30.06.2020Version number 6
Trade name: CMP 1K-Epoxy-primer grau
(Contd. of page 5)
51.0.17
The selection of the suitable gloves does not only depend on the material, but also on further marks of quality
and varies from manufacturer to manufacturer.
·
Penetration time of glove material
Butyl rubber gloves with a thickness of 0.4 mm are resistant to:
Acetone: 480 min
Butyl acetate: 60 min
Ethyl acetate: 170 min
Xylene: 42 min
Butyl rubber gloves with a thickness of 0.4 mm are solvent resistant for 42- 480 minutes. As protective
measure, we recommend that users and responsible persons for work safety assume solvent resistance length
of 42 minutes. Considering the data in section 3 of this SDS, one can assume longer resistance length in
particular cases.
·
Eye protection:
Tightly sealed goggles
*
SECTION 9: Physical and chemical properties
·
9.1 Information on basic physical and chemical properties
·
General Information
·
Appearance:
Form:
Aerosol
Colour:
According to product specification
·
Odour:
Characteristic
·
Odour threshold:
Not determined.
·
pH-value:
Not determined.
·
Change in condition
Melting point/freezing point:
Undetermined.
Initial boiling point and boiling range:
Not applicable, as aerosol.
·
Flash point:
Not applicable, as aerosol.
·
Flammability (solid, gas):
Not applicable.
·
Ignition temperature:
240 °C (464 °F)
·
Decomposition temperature:
Not determined.
·
Explosive properties:
Not determined.
·
Explosion limits:
Lower:
1.2 Vol %
Upper:
26.2 Vol %
·
Vapour pressure at 20 °C (68 °F):
4000 hPa (3000.2 mm Hg)
·
Density at 20 °C (68 °F):
0.8 g/cm³ (6.7 lbs/gal)
·
Relative density
Not determined.
·
Vapour density
Not determined.
·
Evaporation rate
Not applicable.
·
Solubility in / Miscibility with
water:
Not miscible or difficult to mix.
·
Partition coefficient: n-octanol/water:
Not determined.
·
Viscosity:
Dynamic:
Not determined.
(Contd. on page 7)
GB