Troubleshooting guide

SECTION 4

MAINTENANCE

7. [1] Plug the Ribbon Connector (blue side up) into the space under the Latch.

[2] Close the Latch.

8. [1] Slide the Service Station into the Service Station port until it touches the bar. Align with tracks

along sides and Guide on Service Station dock floor.

[2] Look down through the Top Cover to make sure Service Station is aligned with the bar.

IMPORTANT! Service Station must be perfectly aligned with bar to prevent misalignment

and operating problems.

9. GENTLY push the Service Station while

turning the large Gear on right side of Print

Engine clockwise. Gear should engage

gear on Service Station Roller and pull it

in. Once the Service Station starts moving,

stop turning the gear. Powering up the unit

will pull the Service Station the rest of the

way in. NOTE: Make sure the wick

hanging below the Service Station is inside

the plastic trough inside the Ink Tank

Station to prevent ink seepage.

NOTE: Service Station should operate

smoothly. If it binds or makes irregular

noises, reinstall the Service Station.

Lubricate Side Tracks and Guide if necessary.

10. Close Clamshell Cover. Replace the Exit Roller Door and Close the Front Cover.

CAUTION

OPERATE AND HOLD ONTO BOTH LATCHES WHEN OPENING AND

CLOSING THE CLAMSHELL COVER TO PREVENT DAMAGE. DO NOT

ALLOW THE ASSEMBLY TO DROP BY ITSELF WHEN CLOSING.